Spunding valve

[uberg33k]

I was just wondering what people here are using for a spunding setup. I know there are some resources out there for building your own, but most builds seem a bit cobbled together. I was wondering if someone around here has developed something a bit more elegant or found a product at retail they prefer.

[Owenbräu]

ImageUploadedByTapatalk1461775935.659785.jpg (345.67 KiB) Viewed 8778 times

ImageUploadedByTapatalk1461775884.133735.jpg (434.58 KiB) Viewed 8778 times

[Bryan R]

Very similar to Ancient's

[caedus]

Where in the hell can I find the piece that attaches from the ball lock to the stainless tee? I have been trying to find one for a while now, but just have been using a 1 inch section of tubing.

[Bryan R]

http://www.amazon.com/Weatherhead-9100X ... ge_o03_s01

[Kit_B]

Here is a stainless equivalent, minus the swivel.
https://www.brewhardware.com/product_p/ffltomnpt.htm

[Bilsch]

Many styles for a spundungsaparat. I arranged in this way to keep any solids or liquids that might come out, although rare chance, out of the gauge internals and hopefully less resident time in the relief check ball and spring area.

[Brody]

[Roachbrau]

Mine is identical to Bryan's. I like Bilsch's idea though, I'm going to go swap the position of the guage and the keg connector on the tee now!

[Owenbräu]