Page 1 of 5
Spunding valve
Posted: Wed Apr 27, 2016 12:45 pm
by uberg33k
I was just wondering what people here are using for a spunding setup. I know there are some resources out there for building your own, but most builds seem a bit cobbled together. I was wondering if someone around here has developed something a bit more elegant or found a product at retail they prefer.
Re: Spunding vavle
Posted: Wed Apr 27, 2016 12:52 pm
by Owenbräu
- ImageUploadedByTapatalk1461775935.659785.jpg (345.67 KiB) Viewed 8713 times
- ImageUploadedByTapatalk1461775884.133735.jpg (434.58 KiB) Viewed 8713 times
Re: Spunding vavle
Posted: Wed Apr 27, 2016 12:58 pm
by Bryan R
Very similar to Ancient's
Re: Spunding vavle
Posted: Wed Apr 27, 2016 1:23 pm
by caedus
Where in the hell can I find the piece that attaches from the ball lock to the stainless tee? I have been trying to find one for a while now, but just have been using a 1 inch section of tubing.
Re: Spunding vavle
Posted: Wed Apr 27, 2016 1:27 pm
by Bryan R
Re: Spunding vavle
Posted: Wed Apr 27, 2016 1:35 pm
by Kit_B
Re: Spunding vavle
Posted: Wed Apr 27, 2016 2:12 pm
by Bilsch
Many styles for a spundungsaparat. I arranged in this way to keep any solids or liquids that might come out, although rare chance, out of the gauge internals and hopefully less resident time in the relief check ball and spring area.
Re: Spunding vavle
Posted: Wed Apr 27, 2016 3:35 pm
by Brody
Re: Spunding vavle
Posted: Wed Apr 27, 2016 3:50 pm
by Roachbrau
Mine is identical to Bryan's. I like Bilsch's idea though, I'm going to go swap the position of the guage and the keg connector on the tee now!
Re: Spunding vavle
Posted: Wed Apr 27, 2016 4:26 pm
by Owenbräu