Re: Techbrau's low oxygen brewing system
Posted: Tue Jun 07, 2016 8:06 pm
German Brewing
The German Brewing Forum Welcomes You
http://forum.germanbrewing.net/
Techbrau's low oxygen brewing system
Page 4 of 5
Re: Techbrau's low oxygen brewing system
Posted: Tue Jun 07, 2016 8:13 pm
Re: Techbrau's low oxygen brewing system
Posted: Tue Jun 07, 2016 11:15 pm
Don't go too small. The kegs of beer don't last as long
Re: Techbrau's low oxygen brewing system
Posted: Wed Jun 08, 2016 5:13 am
Re: Techbrau's low oxygen brewing system
Posted: Fri Jun 10, 2016 11:54 pm
Really dig that setup. Did you drill it out or find a kettle like that?
Re: Techbrau's low oxygen brewing system
Posted: Sat Jun 11, 2016 3:05 am
It's this one:
https://www.morebeer.com/products/8-gal ... -duty.html
If I could change the kettle, I'd increase the height and decrease the diameter, as well as move the top inlet up a few more inches.
https://www.morebeer.com/products/8-gal ... -duty.html
If I could change the kettle, I'd increase the height and decrease the diameter, as well as move the top inlet up a few more inches.
Re: Techbrau's low oxygen brewing system
Posted: Thu Jul 07, 2016 2:13 pm
Re: Techbrau's low oxygen brewing system
Posted: Thu Jul 07, 2016 7:14 pm
Re: Techbrau's low oxygen brewing system
Posted: Wed Oct 05, 2016 10:36 am
Re: Techbrau's low oxygen brewing system
Posted: Wed Oct 05, 2016 6:12 pm
During the siphon, some CO2 can come out of solution due to the movement of the beer and the slight decrease in the headspace pressure caused by burping the keg. If this CO2 forms a bubble in the dip tube or liquid line, it will stop the siphon.
Assuming you still have positive pressure inside the kegs, you can simply restart the siphon by briefly disconnecting the gas jumper line, burping the receiving keg, then reconnecting the gas jumper.
Assuming you still have positive pressure inside the kegs, you can simply restart the siphon by briefly disconnecting the gas jumper line, burping the receiving keg, then reconnecting the gas jumper.