Time to amend the Bavarian Helles Paper?
Moderator: Brandon
- lupulus
- Apprentice Brewer
- Posts: 206
- Joined: Wed May 11, 2016 8:35 pm
Time to amend the Bavarian Helles Paper?
Hello everyone,
Hope you take this comment as constructive. I am providing some background to explain what prompted it.
A very good brewer with many lager medals (from our brewing club in Austin) has followed the key processes of the paper and observed that 100mg SMB/L of brewing water is making his beer worse, not better. He has tried the process 5 times.
My own experience was that 100mg SMB/ L was too much. I decreased the dose after 5 brews, and I am now at about 15mg/ L.
I purposely did not mention anything when he brought up the paper so that I did not introduce a bias. My best guess based on the anecdotal evidence of my own brewing is that the threshold for sulfury taste varies with yeasts and processes, so I do not get involved unless someone asks a specific question.
I understand, maybe wrongly, that nobody used 100mg / L anymore. If this is the case, the paper is no longer a good starting point, as the body of evidence that all of us are accumulating is not based nor even close to what the paper recommends.
Comments? Thoughts?
No problem if you disagree.
Cheers,
Ricardo
Hope you take this comment as constructive. I am providing some background to explain what prompted it.
A very good brewer with many lager medals (from our brewing club in Austin) has followed the key processes of the paper and observed that 100mg SMB/L of brewing water is making his beer worse, not better. He has tried the process 5 times.
My own experience was that 100mg SMB/ L was too much. I decreased the dose after 5 brews, and I am now at about 15mg/ L.
I purposely did not mention anything when he brought up the paper so that I did not introduce a bias. My best guess based on the anecdotal evidence of my own brewing is that the threshold for sulfury taste varies with yeasts and processes, so I do not get involved unless someone asks a specific question.
I understand, maybe wrongly, that nobody used 100mg / L anymore. If this is the case, the paper is no longer a good starting point, as the body of evidence that all of us are accumulating is not based nor even close to what the paper recommends.
Comments? Thoughts?
No problem if you disagree.
Cheers,
Ricardo
Ich trinke Bier nur an Tagen die mit G enden , und Mittwochs
- Owenbräu
- German Brewing
- Posts: 1196
- Joined: Tue Dec 22, 2015 8:23 pm
Re: Time to amend the Bavarian Helles Paper?
You are exactly correct. We addressed it in the updated version (v2). We are addressing it again in another update (v3), with pretty much exactly what you've observed and found to be an adequate dose.
- The best do the basics better -
- lupulus
- Apprentice Brewer
- Posts: 206
- Joined: Wed May 11, 2016 8:35 pm
Re: Time to amend the Bavarian Helles Paper?
A few suggestions:
Mash intervals: Although I agree with the general guideline, to have the rests in the paper, some type of mixing is required. I suggest stating that the reader may have to adapt the durations to their process.
Boiling: Again, I agree with the general guideline, but this had led some brewers to cloudy wort (not sufficient boil vigor). It did happen to me once when using the same process with Avangard malts (these malts need a longer or more vigorous boil in my system, other malts may need it too). I suggest stating that the wort going into the fermenter should be clear; if not, your boil was not vigorous enough.
Setting the spunding valve: 0.8 bar may or may not be the best setting depending on the beer temp at transferring. If the beer finishes fermenting when still warm, the pressure at 0C will be lower than 0.8 bar. The easiest would be to set the valve when the beer is lagering at 0C.
Mash intervals: Although I agree with the general guideline, to have the rests in the paper, some type of mixing is required. I suggest stating that the reader may have to adapt the durations to their process.
Boiling: Again, I agree with the general guideline, but this had led some brewers to cloudy wort (not sufficient boil vigor). It did happen to me once when using the same process with Avangard malts (these malts need a longer or more vigorous boil in my system, other malts may need it too). I suggest stating that the wort going into the fermenter should be clear; if not, your boil was not vigorous enough.
Setting the spunding valve: 0.8 bar may or may not be the best setting depending on the beer temp at transferring. If the beer finishes fermenting when still warm, the pressure at 0C will be lower than 0.8 bar. The easiest would be to set the valve when the beer is lagering at 0C.
Ich trinke Bier nur an Tagen die mit G enden , und Mittwochs
- Weizenberg
- German Brewing
- Posts: 843
- Joined: Wed Nov 11, 2015 2:11 pm
- Contact:
Re: Time to amend the Bavarian Helles Paper?
Good points on boiling and mash intervals (which need a complete rework imo), but I am not sure about your comments on conditioning lager. As the beer transfers to conditioning, the whole point is that is still has residual sugar left and the now (rather sluggish) ongoing fermentation carbonates as well as decomposes unwelcome byproducts.
A setting of 0.5-0.8 BAR at 3-5C is rather classic and amply described in "Abriss" for eg.
That section probably needs a lot of clarification it seems....
A setting of 0.5-0.8 BAR at 3-5C is rather classic and amply described in "Abriss" for eg.
That section probably needs a lot of clarification it seems....
The Quest for Edelstoff - http://edelstoffquest.wordpress.com
- lupulus
- Apprentice Brewer
- Posts: 206
- Joined: Wed May 11, 2016 8:35 pm
Re: Time to amend the Bavarian Helles Paper?
Ich trinke Bier nur an Tagen die mit G enden , und Mittwochs
- Weizenberg
- German Brewing
- Posts: 843
- Joined: Wed Nov 11, 2015 2:11 pm
- Contact:
Re: Time to amend the Bavarian Helles Paper?
Rest assured that I never doubt your honourable intentions
Yes. Indeed. Setting the pressure initially at 0.8 is *sometimes* done. It does end up at the correct setting for the right carbonation at target volume though.
Using a bit more pressure initially is a slightly more advanced technique and I agree that the introduction to lager conditioning is a poor place for mentioning this.
Yes. Indeed. Setting the pressure initially at 0.8 is *sometimes* done. It does end up at the correct setting for the right carbonation at target volume though.
Using a bit more pressure initially is a slightly more advanced technique and I agree that the introduction to lager conditioning is a poor place for mentioning this.
The Quest for Edelstoff - http://edelstoffquest.wordpress.com
- Weizenberg
- German Brewing
- Posts: 843
- Joined: Wed Nov 11, 2015 2:11 pm
- Contact:
Re: Time to amend the Bavarian Helles Paper?
Rest assured that I never doubt your honourable intentions
Yes. Indeed. Setting the pressure initially at 0.8 is *sometimes* done. It does end up at the correct setting for the right carbonation at target volume though.
Using a bit more pressure initially is a slightly more advanced technique and I agree that the introduction to lager conditioning is a poor place for mentioning this.
Yes. Indeed. Setting the pressure initially at 0.8 is *sometimes* done. It does end up at the correct setting for the right carbonation at target volume though.
Using a bit more pressure initially is a slightly more advanced technique and I agree that the introduction to lager conditioning is a poor place for mentioning this.
The Quest for Edelstoff - http://edelstoffquest.wordpress.com
- mchrispen
- Apprentice Brewer
- Posts: 167
- Joined: Mon Apr 25, 2016 2:15 pm
- Location: Austin, TX
- Contact:
Re: Time to amend the Bavarian Helles Paper?
weiz... doubt him please or he is impossible to be around!
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- Weizenberg
- German Brewing
- Posts: 843
- Joined: Wed Nov 11, 2015 2:11 pm
- Contact:
Re: Time to amend the Bavarian Helles Paper?
He's got the latest copy of Abriss. It's all in there
The Quest for Edelstoff - http://edelstoffquest.wordpress.com
Who is online
Users browsing this forum: No registered users and 6 guests