Spunding Valve Pressure Dropping

How are you fermenting?

Moderator: Brandon

User avatar
Apprentice Brewer
Posts: 112
Joined: Sun Jul 03, 2016 10:58 am

Re: Spunding Valve Pressure Dropping

Postby Nick_D » Sat Aug 20, 2016 6:58 am

I've had this same problem (leaky keg/spunding valve). In my case, I eventually found I had a few slow leaks.

-On one of the points of the valve assembly itself (which I found by submerging it in water with internal CO2 pressure in the valve. Found the bubbling spot and fixed it).

-Also my gas post was allowing gas to escape with the extra weight of the valve, causing it to tip lopsided and lose the seal. To fix this, I wrapped a decent amount of plumbers tape around the gas post, with a little keg lube. Makes it a bit harder to get the QD on, but it's solid, and the unbalanced weight of the valve assembly is not compromising the seal. I suppose oversize rubber post seals would be similar in effect.

- Thirdly, my keg lid's pressure relief valve was not screwed down quite as tightly as it could be, and was also a slow leak.

When you are sure you have all your leaks sorted, test it by filling your empty keg with some CO2, say 10 PSI or so. Connect your Spunding valve, and take careful notice of the reading. Then come back and check it a few hours later. Keep checking it. Leave it overnight even. That gauge should go nowhere (unless there is a noticeable temperate shift in the room). Then you know you have it sorted.
User avatar
German Brewing
Posts: 1196
Joined: Tue Dec 22, 2015 8:23 pm

Re: Spunding Valve Pressure Dropping

Postby Owenbräu » Mon Aug 22, 2016 10:39 pm

Is your gas post shortened? Is the keg full to the top? The less headspace, the more responsive that small volume of gas will be to temperature changes. I've seen mine drop 4-5 psi as I cool to lagering temps.
- The best do the basics better -
Posts: 64
Joined: Wed Jul 13, 2016 11:57 am

Re: Spunding Valve Pressure Dropping

Postby phishie » Tue Aug 23, 2016 8:38 am

I have not shortened my gas post yet so there is about 200-300 ml of head space. On the to do list.
User avatar
German Brewing
Posts: 843
Joined: Wed Nov 11, 2015 2:11 pm

Re: Spunding Valve Pressure Dropping

Postby Weizenberg » Sun Aug 28, 2016 8:50 am

It depends on the temperature. Eventually, as it gets colder, your reading on the PRV will drop. That's normal. If the temperature is constant and it drops, then you have a leak.
The Quest for Edelstoff - http://edelstoffquest.wordpress.com

Who is online

Users browsing this forum: No registered users and 2 guests