Kegging with spunding valve
Moderator: Brandon
-
- Posts: 4
- Joined: Wed May 18, 2016 9:28 pm
Kegging with spunding valve
I am hoping someone can give me some advice - I know next to nothing about homebrew kegging.
I am considering getting into kegging (and with implementing the full LODO process in mind), but to keep costs down just purchasing a 2nd hand 19L corny keg and a spunding valve only (no CO2 or regulator etc). Is this all I need? Or would this be too impractical to actually use (e.g no ability to purge the keg etc)?
Please give me your thoughts on whether this is possible, or not practical (or if I need anything further).
Cheers!
I am considering getting into kegging (and with implementing the full LODO process in mind), but to keep costs down just purchasing a 2nd hand 19L corny keg and a spunding valve only (no CO2 or regulator etc). Is this all I need? Or would this be too impractical to actually use (e.g no ability to purge the keg etc)?
Please give me your thoughts on whether this is possible, or not practical (or if I need anything further).
Cheers!
- Brody
- Assistant Brewer
- Posts: 326
- Joined: Sat Nov 14, 2015 11:30 pm
- Location: Philadelphia, Pennsylvania
Re: Kegging with spunding valve
Yea, you would need the C02 to dispense and purge.
-
- Posts: 4
- Joined: Wed May 18, 2016 9:28 pm
Re: Kegging with spunding valve
Thanks for that. Seems fairly obvious but thought I'd ask the question.
- Owenbräu
- German Brewing
- Posts: 1196
- Joined: Tue Dec 22, 2015 8:23 pm
Who is online
Users browsing this forum: No registered users and 3 guests